Home Security System User Manual

28
To test signal strength/coverage of the main unit to Siren follow the procedure below.
Wireless Siren Auto Test
1. Set dipswitches 1 and 5 to on.
2.
The strobe on the siren will flash every 5 seconds, and the
main unit will beep out the signal strength every 5 seconds.
The beeps range from 1-10. The minimum acceptable
strength is 3.
Note: if the 3 beeps are not achieved, relocate the siren
slightly. If the 3 beeps are still not achieved then relocate
the siren closer to the main unit.