FlashFoot 2 Kit Single, Black Bonded Manual

FlashFoot 2

* Bill of materials shown is for a single FlashFoot 2 assembly.

PAGE 1
FlashFoot 2 * Bill of materials shown is for a single FlashFoot 2 assembly. © 2016 IronRidge, Inc. All rights reserved. Visit www.ironridge.com or call 1-800-227-9523 for more information. FM-FF2-MAN REV 1.
PAGE 2
Installation Tools Required: tape measure, chalk line, stud finder, roofing bar, caulking gun, driver with 1/4” bit and 7/16” hex socket. 1 2 3rd course 3rd course Rafter 2nd course 2nd course 1st course 1st course Locate rafters and snap vertical and horizontal lines to mark flashing locations. Drill 1/4” pilot holes, then fill with roofing manufacturer’s approved sealant. 3 Line up pilot hole with flashing hole and insert lag bolt with bonded washer through flashing.