Conduit Mount Flashing (4) pack Black Manual

Conduit Mount

* Bill of materials shown is for a single Conduit Mount assembly.

1.5

1.7

3.8

12.0

3.0

4.5

9.0

This Edge Towards Roof Ridge

Conduit Mount Cap can be

installed in either orientation shown

NO.

DESCRIPTION

ASSY, CLAMP, CONDUIT

SCREW, NO.14 x 2.75"

ASSY, CAP, CONDUIT, BLACK

WASHER, EPDM BACKED

ASSY, FLASHING

WEIGHT:

SHEET 1 OF 1

SIZE

SCALE:1:4

DO NOT SCALE DRAWING

KIT, CONDUIT MOUNT

0.76 lbs

PAGE 1
Conduit Mount 1 3 3.8 1.5 2 1.7 4 This Edge Towards Roof Ridge 5 12.0 3.0 Conduit Mount Cap can be installed in either orientation shown 4.5 9.0 NO. 1 2 3 4 5 DESCRIPTION ASSY, CLAMP, CONDUIT SCREW, NO.14 x 2.75" ASSY, CAP, CONDUIT, BLACK WASHER, EPDM BACKED ASSY, FLASHING KIT, CONDUIT MOUNT SIZE A SCALE:1:4 DO NOT SCALE DRAWING WEIGHT: 0.76 lbs SHEET 1 OF 1 * Bill of materials shown is for a single Conduit Mount assembly. © 2017 IronRidge, Inc. All rights reserved. Visit www.ironridge.
PAGE 2
Installation Tools Required: roofing bar, caulking gun with approved sealant, drill with 7/16” socket. Sizing: adjustable clamp fits conduit with diameters between 3/4” EMT - 1” EMT. 1 2 3rd course 7/16” hex 2nd course 1st course Slide flashing between 1st and 2nd course, so the top is at least 3/4” above the edge of the 3rd course and the bottom is above the edge of the 1st course. 3 4 Place Conduit Cap on dock and rotate 180 degrees to secure.