Technical Brief

Tech Brief
The Strongest Attachment in Solar
IronRidge FlashFoot2 raises the bar in solar roof
protection. The unique water seal design is both
elevated and encapsulated, delivering redundant layers
of protection against water intrusion. In addition, the
twist-on Cap perfectly aligns the rail attachment with the
lag bolt to maximize mechanical strength.
FlashFoot2
Twist-On Cap
FlashFoot2’s unique Cap design encapsulates
the lag bolt and locks into place with a simple
twist. The Cap helps FlashFoot2 deliver
superior structural strength, by aligning
the rail and lag bolt in a concentric
load path.
Single Socket Size
A custom-design lag bolt allows
you to install FlashFoot2 with
the same 7/16” socket size
used on other Flush Mount
System components.
Three-Tier Water Seal
FlashFoot2’s seal architecture utilizes three
layers of protection. An elevated platform
diverts water away, while a stack of rugged
components raises the seal an entire inch.
The seal is then fully-encapuslated by the
Cap. FlashFoot2 is the rst solar attachment
to pass the TAS-100 Wind-Driven Rain Test.
Water-Shedding Design
An elevated platform diverts water
away from the water seal.