FX Rail-Less Engineering

FX Engineering & Design Guide
IRONRIDGE CONFIDENTIAL
Page 14 of 21
Therefore, in the image above, (3) pieces of Trim and (3) End Caps (2 Left and 1 Right) are
appropriate
Both of the two arrays in the image below are staggered. They both have modules with partially-
exposed southern edges. The designer can choose to omit partial pieces of Trim in such cases,
based on the aesthetic benefit versus the cost of the part.
In this case, the designer decided to include partial pieces of Trim as indicated by the red
arrows, and omit a partial piece of trim indicated by the yellow arrow. Trim is made from
aluminum and can be cut in the field using an electric saw. The two partial pieces shown could
be cut from a single piece of trim.
This design would require (6) pieces of Trim (landscape), (5) left End Caps and (4) right End
Caps.
.