FX Rail-Less Installation

FX SYSTEM INSTALLATION MANUAL - 15© 2018 IRONRIDGE, INC. VERSION 1.50
5. INSTALL MODULES
D. CONNECT MODULES WITH BRIDGE FX
Slide a bridge onto rst and second modules to secure
them.
Repeat steps above for all modules in the rst row.
 You can manage wires by using your preferred PV wire clips. See
the Wire Management section for detailed information.
E. ADJUST FX MOUNT HEIGHT
If there are undulations in the roof, you will need to adjust
the mounts so that all of the modules are at the same
level. Each mount can be raised and lowered by rotating
the drive nut with a 7/16" hex drive.
To lower the module height, rotate the drive nut clockwise.
To raise the module height, rotate the drive nut
counterclockwise.
 Double-check to make sure that the alignment and height of the
modules are level and in plane. All modules should run parallel to
the roof edge.
D
Bridge FX
E
Lowering module height Raising module height