FX Rail-Less Installation

FX SYSTEM INSTALLATION MANUAL - 12© 2018 IRONRIDGE, INC. VERSION 1.50
3. INSTALL FIRST ROW OF MOUNT FX
C. ADJUST MOUNT FX HEIGHT
If needed, mounts can be lowered and raised in order to
accommodate any roof undulations.
To lower the module height, rotate the drive nut clockwise.
To raise the module height, rotate the drive nut
counterclockwise.
 The total height adjustability of Mount FX is 1".
 Mount FX is pre-assembled to half of that range.
Lowest Position
Pre-Assembled Position
Highest Position
Top of Vertical Bolt
4. INSTALL TRIM FX AND BRIDGE FX
A. CONNECT TRIM FX TO FIRST MOUNT LOCATION
Align one end of the trim with the perimeter mark for the array.
Engage and catch the top of the trim. Then pull down on the lever and push to slide trim into place.
 Go in at a shallow insertion angle when engaging catch of Trim FX with Mount FX.
C