Install Manual

Table Of Contents

CAMO

A. SLIDE INTO RAIL

Slide CAMO into rail channel far enough to clear the

module frame. CAMO requires 6" of clearance from end of

rail.

B. PLACE MODULE

Place module on rails (module cells not shown for clarity).

When installing CAMO the module can overhang the rail



C. PULL TOWARDS END

Pull CAMO towards rail ends, at 45 degree angle, so the



D. SECURE TO FRAME

Rotate handle with an upwards motion until CAMO snaps

into rail channel. Ensure CAMO bonding pins are fully

seated on top of module frame.

FRAME COMPATIBILITY

CAMO has been tested or evaluated with all modules

listed in the Module Compatibility section having frames



module being used meets the dimension requirements.

➢ For installations with Hanwha Q CELLS modules with 32 mm

frame heights, the maximum ground snow is 45 PSF (33 PSF

module pressure).

➢ CAMO’s compatiblity with Canadian Solar modules is limited to

the HiDM5 (CS1Y) modules.

6" Clearance