Manual

Insert Tile Replacement Flashing, lower onto base

and apply pressure over the threaded post until it

dimples the ashing.

Place L-Foot over top of dimple and tap with hammer

to punch the threaded posted through the ashing.

Ensure punched pieces of ashing are cleared away.

Installation

Tools Required: Tape measure, chalk, approved sealant, hammer, and driver with 1/4” bit and 1/2” hex socket

Remove tile and mark rafter. Use base as guide to

drill 1/4” pilot hole and ll with roong manufacturer’s

approved sealant.

Structural Certication

Designed and Certied for Compliance with the International Building Code & ASCE/SEI-7.

Water Seal Ratings

Water Sealing Tested to UL 441 Section 27 “Rain Test” and TAS 100(A)-95 “Wind Driven Rain Test” by Intertek. Ratings applicable for concrete

tile roofs having slopes between 2:12 and 12:12. Tested and evaluated without sealant. Any roong manufacturer approved sealant is allowed.

UL 2703

Conforms to UL 2703 Mechanical and Bonding Requirements. See IronRidge Flush Mount Installation Manual for full ratings.

Insert lag with bonded washer through base into

pilot hole and fully seat. Base can be installed in

either orientation shown. Seal or ash base as

needed. If deck level ashing is required, approved

ashing methods include user-supplied, adhesive-

backed, exible ashing.

Form ashing as needed to sit ush with surrounding

tiles. Position L-Foot in desired orientation and torque

hardware to 132 in-lbs (11 ft-lbs).

Attach rail to either side of L-Foot with bonding

hardware. Ensure L-Foot does not extend above rail.

Torque hardware to 250 in-lbs (21 ft-lbs).

3 4

5 6

Rafter

Dimple

Tap With

Hammer

Torque to 132 in-lbs

Torque to

250 in-lbs

Tighten Until

Fully Seated