Manual

Knockout Tile

NO.

DESCRIPTION

ASSY, PEDESTAL 1

SCREW, LAG, HEX, 5/16, 4.0L

TILE REPLACEMENT FLASHING, S

TILE REPLACEMENT FLASHING, FLAT

TILE REPLACEMENT FLASHING, W

L-1X5, BLACK

WASHER, BONDED

NUT, FLANGE 5/16-18 SST

WEIGHT: 2.754 LBS

SHEET 1 OF 1

SIZE

SCALE:1:1

DO NOT SCALE DRAWING

KNOCKOUT TILE

PAGE 1
Knockout Tile 3 8 7 6 4 5 2 7 1 NO. DESCRIPTION 1 ASSY, PEDESTAL 1 2 SCREW, LAG, HEX, 5/16, 4.0L 3 TILE REPLACEMENT FLASHING, S 4 TILE REPLACEMENT FLASHING, FLAT 5 TILE REPLACEMENT FLASHING, W 6 L-1X5, BLACK 7 WASHER, BONDED 8 NUT, FLANGE 5/16-18 SST © 2019 IronRidge, Inc. All rights reserved. Visit www.ironridge.com or call 1-800-227-9523 for more information. KNOCKOUT TILE SIZE A SCALE:1:1 DO NOT SCALE DRAWING WEIGHT: 2.754 LBS SHEET 1 OF 1 KOB-01-MAN REV 1.
PAGE 2
Installation Tools Required: Tape measure, chalk, approved sealant, hammer, and driver with 1/4” bit and 1/2” hex socket 1 2 Tighten Until Fully Seated Rafter Remove tile and mark rafter. Use base as guide to drill 1/4” pilot hole and fill with roofing manufacturer’s approved sealant. 3 Insert lag with bonded washer through base into pilot hole and fully seat. Base can be installed in either orientation shown. Seal or flash base as needed.