Product Manual

Page 13 of 21
Operating Instructions
⚠WARNING
 Always wear eye protection.
 Only use accessories rated at least equal to the maximum speed marked on the tool.
 Do not modify the tool in any way.
 Do not wear gloves, jewelry, or loose clothing.
 Do not use a cracked or chipped grinding wheel.
 Bolt down benchtop grinder before using.
 Do not use in the rain or in a damp location.
 Never reach to pick up a workpiece, a piece of scrap, or anything else that is in or near the
grinding path of the wheel.
 Never stand, or have any part of your body in line with the path of the wheel.
 If a dull thud occurs do not use the wheel! This means the wheel has been damaged and will,
most likely, come apart during normal operations.
 Do not over tighten wheel nut. Excessive tightening can cause the wheel to crack during
operation.
 Always use the grinder’s wheel guards and safety shields.
 ADJUST DISTANCE BETWEEN WHEEL AND TOOL REST to maintain 1/16 in. or less separation
as the diameter of the wheel decreases with use. The value of separation used in the marking is to
be the separation recommended by the manufacturer but shall not be more than 1/8 inch.
 When starting to grind, a harsh impact can break the wheel. Use light pressure when starting to
grind; too much pressure on a cold wheel can cause the wheel to crack.
 Never start the grinder when the wheel is in contact with the workpiece.
 Always hold workpiece firmly against the tool rest.
1. Turn on the tool and allow the tool come up to full speed before touching the wheel.
2. Bring the workpiece up to the wheel, gently and without jarring. Use the tool rest to steadily move
the workpiece over the wheel. Always support the workpiece on the tool rest; do not grind
freehand.
3. Keep the workpiece moving across the face of the wheel so that the grinding wheel wears evenly
from side to side.