Operation Manual

13
- For the first hour, the chronograph shows minutes, seconds and 1/100-seconds, then it shows hours, minutes
and seconds.
* Leading zeros will not be shown in the display.
- One split time may be measured.
* When you take the split time, the display will be frozen for approx. 4 secs to show the split time. After this, the
display changes back to the running chronograph automatically.
To measure elapsed time
1. Press A to start the chronograph.
2. Press B to stop the chronograph.
* You can resume the measurement operation by pressing A.
To measure split time
1. Press A to start a time measurement.
2. Press A again when you want to take the split time.
3. Press A again when you want to take the next split time.
* You may take only one split time and this is not memorized, only shown for 4 secs on the display.
4. Press B to stop the time measurement.
To clear time in current run
1. Press B to stop the chronograph.
2. Hold down D until the chronograph shows all zeros.
* Time in current run is cleared.
Activate the Heart Rate Monitor in the CHRONO Mode
- The HRM is activated automatically when you start the chronometer
- When no chronometer is running, you may activate the HRM by pressing the key D
- When the HRM is active, a heart icon will be shown on the display. As soon as a signal is received, this icon starts
to blink. The received pulse rate will then be shown after a few seconds in the display.
- If no signal is received for about 1 minute, the HRM will deactivate itself automatically (heart icon disappears from
display). By pressing key D you may activate it again.
- When the training zone and (!) the training zone alarm are ON, the watch will give a sound every 5 seconds once
your pulse is out of the training zone . If below (LO): 1 beep, if above (HI) 2 beeps.
Settings for the Heart Rate Monitor
To enter the setting mode for the HRM functions, press and hold key D until the display shows „HR Zone“. Before
this, you will clear the time of your last run (if STW is not 00:00:00) and then, by still holding key D pressed, you will
see USER HOLD SET
Once in the setting mode, the function to adjusts blinks and you may change it by pressing the keys A or B.
By pressing key C, you are getting from function to function.
Press key D to accept all settings and leave the setting mode.