Operation Manual

16
* When TIME 1 or TIME 2 is flashing, press A or B to switch between setting the alarm to refer to Normal Time
(TIME 1) and Dual Time (TIME 2).
* When ON or OFF is flashing, press A or B to turn the chime on (indicated by ON) and off (indicated by OFF).
If chime is turned on, the chime on indicator will be shown after exiting setting screen.
4. Press D to exit the setting screen.
* The alarm turns on, which is indicated by ON and the appearance of the alarm on indicator.
* If there is no button operation for 2-3 minutes at setting screen, the display will return to Alarm mode
automatically.
To turn the alarm on and off
Press A to turn the alarm on (indicated by ON) and off (indicated by OFF).
* If the alarm is turned on, the alarm on indicator will be shown.
11. SERVICE
11.1 RESETTING THE PRODUCT
Hold down A, B, C and D simultaneously, all segments will be “on”, then release the buttons and the product
will be reset.
* After reset, there will not be any measurement of altitude, pressure or temperature until A, C or E is pressed.
* After reset, entering Compass mode will change to calibration screen directly.
11.2 BATTERY REPLACEMENT
Replace the exhausted battery with a CR2032 cell or equivalent.
Altimetermode with altitude change: measures every 2,5 seconds
Altimetermode without altitude change (barometer mode): every 2,5 minutes
Barometermode: measures every 2,5 minutes. Changes to Time mode after 24 hours
Temperature: measures every 2,5 minutes.
CE
HOUR MINUTE
C
REFER TO
T1/T2
CHIME ON/OFF
C C