Instruction Manual

T
hank you very much for purchasing this product, to be able to use the product, be
sure to read this manual.
Treadmill main parameters
1. Running Area: 980*390mm
2. Max User’s Weight: 100KG
3. Set up Size: (L*W*H)1300*655*1230mm
4. Folding Size: (L*W*H)520*655*1270mm
5. Motor : 0.5hp
6. Speed: 1-12.8
7. Mode: “Manual”; “Time countdown”; “Distance countdown”; “Calories countdown”;
“Auto”. In accordance with Monitor instruction.
8. 12 sport modes can be set up by own needs.
Safety
Warning
 Please don’t use this machine with illness, fatigue and drunk.
 Children should use this machine under adults accompany.
 Please wear comfortable clothes, avoid flip flop or skirt when using this machine.
 Please start from suitable sport as excessive exercise may affect health.
 Loading capacity is 100KG, overload may cause damage.
Attention
 It’s common home use machine, please avoid commercial use.
 Please avoid using this machine at fire source location.
 Please exercise in wide space without any danger.
 When use in the floor, please be sure cover the carpet to avoid damage to the
surface.
 When not use, please don’t set it on the place as follows:
A. Overheat, over cold place. B. Outdoors, direct sunlight place
.
C
. Gas stove, near the fire place. D. Cold and more moisture places.
E. Child touch place. F. Soot, water vapor place.
 Please don’t use this machine on the uneven places.
Treadmill Common Error Messages Prompt Description
E01: communication blocked between Electronic and controller.
Solution
When communication line is
blocked between Electronic
and under controller
Please connect again or
change communication line
When Electronic without
signal
Change Electronic to repair
When under controller
without signal
Change under controller to
repair
E02: The controller does not detect the voltage of the motor line.
Solution
Motor cable is not connected Check connection
No voltage output or abnormal
by under controller
Change under controller to
repair
Motor is bad Change motor
E03: When the motor is running, the controller can’t test the speed signal.
Solution
Motor cable is not
connected
Check connection
Under c
ontroller with
abnormal signal
Change under controller to
repair
E05: When the motor is running, current exceeds the rated current.
Solution
Treadmill motor load
exceeds the rated current
Recommend within the
rated current of the motor
Treadmill motor assembly
structure problems, causing
the motor blocked or
resistance
Check the structure of
treadmill
By limiting control system
failure
Change under controller to
repair
E07: Monitor can’t test the signal of security lock.
Solution
Safety Magnet off
Ple
ase set magnet safety
lock correctly
Electronic Safety lock system
malfunction
Change electronic to repair
1
10