P10 User Manual

DC power supply

Select this function, CH1 of the charger will be a DC power supply with adjustable

output voltage 5~24V, and current 0.2~5.0A.

Parallel task selection

Select Parallel charging model. Using one-for-two power cord , with one end

connected to the battery and the other to two output ports of the charger.

It can gather output power in one channel. The battery balance port can be

connected to any balance port of the charger. Match the charger with power supply

and connect the battery , and select this item in the advanced settings menu to set

the parallel task parameters with recommended charging current is 10~16A.

In stand by model. Press and hold the left and right channel selection keys at the

same time to enter the advanced setting menu . The menu items are as follows:

Advanced settings

Under the advanced settings menu,

select system settings to enter the system settings menu.

System Setting Menu

Min. input voltage protection: 10~24V

All tasks in operation will be stopped at once and hint warning of low voltage,

when the input voltage is lower than the input voltage as set up. It will protect the

battery from being discharged when using battery pack as power supply.

Max. input power setting: 100~550W

If the input power is smaller than the max working power(500W), please set up the

parameter as the actual output power as max input, to protect the input power and

enable the charger to work stable.