P20 User Manual

Charge
Balancing port is strongly recommended when charging lipo battery, which can make sure to monitor
voltage on each cell battery and balance it when charging. Warning beeper will yell before start charging
lipo if in non-balance mode (no connecting with balance port).
Current setting range: 0.2~20A. The battery type, cell count and charging current are auto set
accordingly when connecting with BattGo battery.
Discharge
Current setting range: 0.2~1.5A. The battery type, cell count and discharging current are auto set
accordingly when connecting with BattGo battery.
Storage
Current setting range: 0.2~20A. The battery type, cell count and storage current are auto set
accordingly when connecting with BattGo battery.
Destroy
Connect the battery to be scrapped, and select the scrap function in task options, which capable to
discharge the battery to 0V. Current setting range: 0.2~1.5A.
The battery type and cell count are are auto set accordingly when connecting with BattGo battery.
Charging Screen
Press the direction button to shift the charging information, as cell voltage, cell internal resistance,
BattGo information, working parameter. The cell voltage and internal resistance are only on display
in balancing charging mode.The BattGo information will be displayed only when connected to the
BattGo battery, and the cell voltage is able to be displayed without connected to the balance port.
Under the standby interface, long press the CH1 and CH2 button at the same time to enter the
advanced setting menu.
Advanced Settings
Dual task
Select this setting,the charger will charge/discharge/store to the two channel batteries with the same
parameters at the same time. Connect the charger with the power supply and power on,
select this setting on the advanced setting menu to set the task parameters.