P20 User Manual

Under the advanced setting menu, select the system setting into the system setting menu as follows:
System Setting Menu
Min. input voltage protection: 10~31V
All tasks in operation will be stopped at once and hint warning of low voltage,
when the input voltage is lower than the input voltage as set up.
It will protect the battery from being discharged when using battery pack as power supply.
Max. input power setting: 100~1100W
If the input power is smaller than the max working power(800W), please set up the parameter as the
actual output power as max input, to protect the input power and enable the charger to work stable.
BattGo
When the corresponding channel (CH1 output,CH2 output,Power input) connect to a BattGo battery,
you could read this and modify the related parameters of Battgo battery.
Volume
There are 4 options of High Mid Low and Off for volume setting.When the setting is OFF,
it will turn off the operation sound,but not the warning error beep.
Parallel charging
Paralled task
Select this setting, it could output Max Power
to one battery. Find a power splitter or 1/2
power cord, one end connect with the battery,
and the other two ends connect with the
battery output port. The battery balance port
could connect with any of the charger's balance
port. Connect the charger with the power supply
and power on, and connect your battery as required,
select this setting on the advanced setting menu to
set the task parameters.
DC power (CH1)
The charger CH1 is equivalent to a DC power supply when selecting this function, with output voltage
adjustable from 2 to 30V, and current adjustable from 1.0 to 5.0A.