Q8 Max User Manual

Power on Q8 Max smart charger, connect the battery, and short touch the middle key of
the touch board to enter the task setting menu as follows:
Operating the Charger
Task
Battery
Battery and
cell count
Current Setting
Charge，Discharge，Destroy，DC power supply，Storage
LiHv、LiPo、LiIon、LiFe、Pb、NiMh/Cd
LiFe,LiIon,LiPo (1~8S); LiHv (1~7S); Pb (1~12S);
NiMH/Cd (1~16S)
0.2~30.0A
Charge
Balancing port is strongly recommended to be connected when charging LiPo battery,
which can make sure the charger can accurately monitor voltage on each cell battery
and balance it when charging. Warning beeper will yell before start charging LiPo if in
non-balance mode(no connecting with balance port).
Current setting range: 0.2~30.0A
The battery type, cell count and charging current are auto set accordingly when connecting
with BattGo battery.
Discharge
Current setting range: 0.2~3.0A
The battery type, cell count and discharging current are auto set accordingly when
connecting with BattGo battery.
The reference relation between C value and charging time:
charging time ≥60 minutes/ charging C value (e.g. it needs around 60-70 minutes to
complete charging with 1C). Due to differences in battery conversion efficiency, the time to
complete the charging might be extended.