User Manual
Max input power limitation: if the input power fails to reach the max working power (330W), set this parameter
based on the actual output capacity of input power in order to protect it and enable the charger to work stably.
For example, as the power connected is 12V/10A, the value of this item should be 120W.
Min input power: this item can protect the battery from excessive discharge since it’s used as input power. If the
charger tests that the input voltage is lower than the default value, all tasked in operation would be terminated
and there would be a warning of low voltage. For example, if a 6S Lipo battery is used as the input power source,
the value of the item should be 21V to protect the battery from excessive discharge.
Buzzer volume: the default is OFF, the operation sound would be blocked, but not the sound of error warning.
The battgo settings as below will be showed if connect the battgo smart battery:
Bvup!Tupsbhf
Tupsbhf!Wpmubhf
Dibshf!Dvssfou
Dibshf!Wpmubhf
Fydfqujpo!Sfdpse
Cbdl
When default set allow auto storage mode,
the time could be set between 12h-240h
set the storage voltage slightly,
adjustablerangeofvoltages is -0.20V
change charge current slightly,
adjustablerangeofcurrents is between 0.1A to the max charging curren
change charge voltage slightly,adjustablerangeof voltages is -0.10v
Battgo smart battery will record the date include overvoltage,
undervoltage,overtemperature.
Back
26
Auto Storage
Storage Voltage
Charge Current
Charge Voltage
Exception Record
Back
240h
3.80V
2.6A
4.20V
...
BattGO Setting