User's Manual

3
Supply Voltage range 1.7V to 5.5V
RF Synthesizer
1 MHz frequency programming resolution
1 MHz non-overlapping channel spacing at 1 Mbps, 125Kbps and 250 kbps
2 MHz non-overlapping channel spacing at 2 Mbps
Baseband controller
EasyDMA RX and TX packet transfer directly to and from RAM
Dynamic payload length
On-the-fly packet assembly/disassembly and AES CCM payload encryption
8 bit, 16 bit, and 24 bit CRC check (programmable polynomial and initial value)
 •Dimension:


INTRODUCTION
Direct Test Mode is used to control the Device Under Test (DUT) and provides a report back to the
Tester.
1. over HCI or
2. through a 2-wire UART interface
Each DUT shall implement one of the two Direct Test Mode methods in order to test purpose.