Owner's Manual

Tranzlt LINK
4.
Module Installation
Connecting to radio
I Gain adjustment
1) The
Tranzlt LINK
is designed to
install inline with the radio antenna connection
usually
located
on
the back of the radio
in
the dash.
In
some cases this connection may
be
at a
remote radio tuner location. Consult vehicle
manufacturer's information
in
these cases.
2)
Some antenna connections require the use of
an
antenna adapter
in
order to connect
the
Tranzlt LINK.
These adapters are available from most car audio
installation retailers.
3)
Select
the
FM
frequency where you will
access your new audio device.
On
the side
of
Tranzlt LINK
where the
label
indicates
"Tuning
Frequency" there is a two position switch.
Note the position of the switch before
installing
the interface.
If
you have a
local
radio station that occupies either
of
these frequencies (87.9 or 88.3)
please
move the switch to the position that does
NOT match the
local
station.
The position
of
this switch determines the frequency where you
will
access your new audio
input. We recommend choosing one option, and setting one
of
the radio's preset buttons
to represent that station. This easily
accesses your auxiliary
audio input by pressing the
preset button.
Using a
multimeter, identify 12V+ and ground wires behind the radio.
a.
Connect the
Tranzlt LINK
red wire to 12V+ (accessory)
b.
Connect the
Tranzlt LINK black wire to ground
c.
Connect the
vehicle's
antenna into the
Tranzlt LINK
antenna input*
d. Connect the
Tranzlt LINK antenna output into the radio*
*A
vehicle
specific antenna adaptor may be required to make these connections
The rocker switch
supplied
with the Tranzlt LINK will
turn the device on and off. When the
switch is
in
the on position, the Tranzlt LINK will
interrupt the incoming antenna
signal
to
deliver
the
cleanest signal possible
from your device through your
FM
radio.
To
regain
standard AM/FM reception, move the switch to the
Off
position.
Note:
Regardless
of
switch position, the
Tranzlt LINK will
provide power to your device for
charging.
4)
Once the
Tranzlt LINK
is
installed correctly,
be sure to
properly set the audio level.
When set correctly,
the audio
level
of the
Tranzlt LINK will
match the
volume
of
typical
FM radio stations.
Radio
Tuning
Frequency
Use
to
se
lect
best operating
frequency for your ar
ea
Audio
Input
·
l
,S77~
-
~
-
-.
:~=;
.
cb
s1mple
"'
BACK
VIEW
G.\
l
ct
H
Gain
Adjustment
U
se
to match
volume
of
1
577
05
to volume
of
FM
radio stations
Antenna
Out
r
I~
"-
l
__
to
-
F
M
r
a
-
dio*
-~
_;
EJEB
r--
-
I~'T"TT
Ground
Connection
~
Connect to a
clea
n
gr
ou
nd
point
Factory
or
Upgraded
Radio*
On/Off
Switch
9/16" mounting
hole
Connects
to
Power
Source
'---------1---
ACC
12VDC
2A F
use
Power
when key-on