User Manual

Mounting Options
The BluClik has two mounting options. Please choose your preference, then follow the directions for best results.
Option 1: Steering Wheel Mount
1) Determine the best side of the steering wheel for mounting the remote.
2) Place the arm of the mount on the front side of the steering wheel.
3) Thread the Velcro strap around the arm, with the loop positioned on the backside of the steering wheel, and
pull tight and keep tension while attaching.
4) Place the remote in the holder with the + symbol at the top.
Option 2: Dash Mount
1) Determine the best, at surface, mounting location.
2) Ensure that the surface is free of dirt and oil, clean with a soft cloth and rubbing alcohol if necessary.
3) Place the remote in the holder with the + symbol at the top or toward the front of the vehicle.
velcro strap
loop
A Division of AAMP of America | 13190 56th Court, Clearwater, FL 33760
www.isimplesolutions.com
[e-mail]
866-788-4237
mount
arm
Warning:
This equipment may be reset by unintentional electrostatic discharge during operation.
Exposure to direct sunlight or extreme heat may cause damage or malfunction.
FCC Class B Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installa-tion. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1. Re-orientate or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit dierent from that of which the receiver is connected.
4. Consult the dealer or an experienced radio / television technical for help.
Notice:
The changes or modications not expressly approved by the party responsible compliance could void the user authority to operate
the equipment.