Owner's Manual

ManualsBrandsiSimple ManualsApple & Android integrationiSimple GateWay ISIM74

ATTENTION

INSTALLER!!

Quick Start Guide

• Before

removing

the

radio,

visit

www.isimplesolutions.com

to

verify

vehicle

compatibility

and

that

you have

the

latest

instruction

manual.

• This guide covers

the

general procedure

for

installation

and

initial

funct

ion

of

the

GateWay.

Please read

the

instruction

manual

in

its

entirety

and

review

the

radio

quick

reference cards

provided

in

the

kit

and

at

www.isimplesolutions.com.

• Safely remove

the

vehicle's

radio

and proceed

as

follows:

STANDARD INSTALLATION

INSTALLING WITH

BLUETOOTH

ADD-ON (ISBT21):

1. Connect iPod cable

into

PORT

1

of

the GateWay

Module

2. Connect

HD

Radio Tuner

(HDRT),

Sirius Satellite

Radio Adapter Cable

(ISSR11}

or

AUX

cable into

PORT

2

of

the

GateWay

Module

1. Connect

ISBT21

into

PORT

1

of

the

GateWay

Module

2.

Connect iPod cable,

HD

Radio Tuner

(HDRT},

Sirius Satellite Radio Adapter Cable {ISSRll}

or

AUX

cable

into

PORT

2

of

the GateWay Module

3.

Set

the

dip-switches according

to

the

Dip-Switch section

of

the instruction manual.

4.

Connect

the

Radio/Vehicle connection harness

(PGH_}

to

the

Vehicle Harness in

the

dash

5. Connect

the

Radio/Vehicle connection harness

(PGH_}

to

the Connectors on the back

of

the

Radio

6.

Connect

the

Black, 24-pin

con111ector

of

the

Radio/Vehicle connection harness

{PGH_)

to

the

GateWay

7. Turn

the

key to

the

accessory position,

turn

on radio and WAIT 3 MINUTES (Do

not

touch anything}

8.

Depending on your radio, press

the

"BAND", "SAT", "SIRIUS",

"XM",

"RADIO"

or

"AUX"

button

until

the

radio enters the satellite mode. (Consult instruction manual

for

Honda and Toyota applications using

CO

changer emulation mode.)

9. Once the radio enters the satellite

mode

you will need

to

select

the

Ga

teWay source by IMMEDIATELY

pressing

the

tune

button

or

turning

the

tune knob so

that

iPod,

AUX,

BT,

HD

Radio,

SAT

or

Sirius

is

displayed on the radio. The radio should auto-select the source

that

is

displayed

after

a

few

seconds.

Please Note:

If

radio

times

out

before GateWay source selection is made you

will

have

to

exit

Satellite

mode

by

going

to

AM/FM

or

CD

modes

and

then re-enter Satellite mode

and

make

your

GateWay

source selection IMMEDIATELY (steps 7 & 8}. (Consult instruction manual

for

Honda and Toyota

applications using

CO

changer emulation mode.)

Note: The iPod can be

controlled

in

two

ways.

1. "iPod"

Mode-

iPod

is

controlled from

the

radio

2.

"AUXl"

Mode-

iPod

is

controlled

from

the iPod itself

Please consult instruction manual

and

quick reference cards for

additional radio

and

GateWay

operation details