Freeport 11-ft Octagonal Cantilever Patio Umbrella in Sunbrella Please Do N ot Hesitate to Contact Our Consumer H otline at 800-759-0 9 7 7 with Any Qu estions That May Arise During Assembly or Use of This P roduct! NU6545B • NU6550B • NU6555B NU6575B • NU6585B • NU6590B www.bluewaveproducts.
PACKAGE CONTENTS A – (1) Main Umbrella B – (1) Plastic Water Fillable Stand A F (NU6000JL sold separately) C – (1) Base Pole B D – (1) Swivel Cover G E – (1) Allen Wrench F – (4) Stainless Bolt G – (4) Washer C H H – (1) Threaded Knob I - (1) Crank Handle J - (1) Umbrella Cover D E I J SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble or install the product. • Assemble on level ground. • Keep children away from assembly area.
ASSEMBLY INSTRUCTIONS Carefully check all packaging materials before discarding. Do not assemble if there are missing pieces. Step 1 Put the stand on a level ground where you intend to locate your umbrella. Open the cap on the top of the stand & fill the stand with water. Then tighten the cap. In case you want to move the stand, Step 2 Put the Base pole ( part C ) on the top of the Plastic Water Fillable Stand .
Step 3 Fix the Base Pole ( part C ) on the top of the Plastic Water Fillable Stand ( part B ) with bolts F & washers G use the Allen Wrench (E) Bottom crank hole C E F G B Step 4 Put the Swivel Cover ( part D ) around the Base Pole ( part C ) . C Bottom crank hole Locking hole for threaded knob side A +/- 1.4” B D Side B +/-1.7” side B Important Notice : Pay attention to the size of the middle hole in the Swivel Cover (part D). Side A / Front Side : +/- 1.4" , Side B / Rear Side : +/- 1.7" .
Step 5 Put the Main Umbella (Part A ) outside the Base Pole ( Part C ) Important Notice : When you put the Main Umbrella outside the Base Pole, make sure the locking holes are on the same side .
Step 6 Fix the Threaded Knob ( Part H ) into the locking hole.
Step 7 There are 3 Crank Holes on your umbrella. Top crank hole for canopy tilting, Bottom crank hole for 360 degree rotation. Middle crank hole for umbrella opening and closing.
Step 8 Squeezing the trigger before attempting to raise the crank house. Fix the Crank Handle (I) into the middle crank hole and turn clockwise to extend the umbrella fully . A 1 I 2 I B Caution: Please pull and loose the umbrella ribs by hand before attempting to open the umbrella by crank.
Step 9
Step 10 Fix the Crank Handle (I) into the top crank hole to tilt your umbrella canopy.
Step 11 I Fix the Crank Handle (I) into the bottom crank hole to rotate your umbrella in 360 degrees.
Step 12 Squeezing the trigger before attempting to lower the crank house. Turn the Crank handle counter-clockwise to close the umbrella. A First Step I Second Step I B Step 13 When not in use, place Umbrella Cover (part J) over the umbrella .