Installation Manual

ManualsBrandsIsland Umbrella ManualsOutdoor LivingIsland Mist 9-ft Octagon Market Umbrella with Mist Cooling System, Breez-Tex Canopy, in Navy Blue

IslandMist

PLEASE READ THIS INSTRUCTION MANUAL CAREFULLY BEFORE STARTING ASSEMBLY AND INSTALLATION

• Maximum 50 psi working pressure.

• Do not posion the umbrella with IslandMist misng kit near or over any electronic appliances.

• Keep small parts away from children and pets.

• Review the parts list to insure all required parts are included in this kit. If you are missing parts or have

damaged parts, DO NOT RETURN the kit to your retailer. Contact Blue Wave Customer Service for

replacement.

NOTE: Take the me necessary to work out how you will run the Misng Tube and where you should posion

the misng Nozzles. Also, note where your water source is and where the lead line supply tubing will run.

Ver. 0821

DIY PUSH-IN 40’ X 1/4” MISTING KIT INSTALLATION MANUAL

Congratulaons.

You have purchased an IslandMist & Umbrella Misng kit Combo package.

Parts included for Assembly & Installaon:

Part Number

NUP4136

NUP4138

NUP4139

NUP4140

NUP4141

NUP4142

NUP4143

NUP4144

For replacement or missing parts please call 800-759-0977.

NU6811NB

40

NUP4148

(NOTE: misting lines are packaged

separately inside umbrella with boom pole)

Summary of content (4 pages)

PAGE 1
IslandMist DIY PUSH-IN 40’ X 1/4” MISTING KIT INSTALLATION MANUAL Congratulations. You have purchased an IslandMist & Umbrella Misting kit Combo package. Parts included for Assembly & Installation: Part Number 40ft NUP4136 NUP4148 (NOTE: misting lines are packaged separately inside umbrella with bottom pole) NUP4138 NUP4139 NUP4140 NUP4141 NUP4142 NUP4143 NUP4144 For replacement or missing parts please call 800-759-0977.
PAGE 2
IslandMist DIY Assembly & Installation Instructions: Step 1: Assembling the Misting Kit: This IslandMist misting kit is specifically designed to attach to the umbrella it was received with.  Set aside the 15 ft. coil of ¼” Misting Tube. Do not cut this tube. It will become the lead line for the kit.  Identify the 8 sections of pre-cut 3.3’ Misting Tube.  Proceed with connecting the Tees to the Misting Tube sections as shown below.
PAGE 3
 Attach the Swivel Nut to one end of the Lead Line (this is where hose will attach).Then run the Lead Line along the umbrella pole up to one of the umbrella ribs and use the Cable Tie to clamp the tubing onto umbrella pole and rib (same for option A or B). NOTE: If you are inserting your umbrella in a patio table that has a hole only big enough for umbrella pole, do NOT run the line down the pole through the hole. This can damage the Lead Line or restrict water flow.
PAGE 4
 Continue wrapping the assembled Misting Tube around the complete circumference of umbrella. Position a Tee with Nozzle at the end of each umbrella rib.  Place one of the Umbrella Clips provided over the Misting Tube about 1-2 inches on the left and the right side of each Tee with Nozzle and adjust Nozzles at 45 degree angle to the ground and away from the covered portion of the umbrella.