Doc. 6140223 Rev.
Wireless Thermostat Installation 1) Determine the thermostat location. a. Approximately 5ft above the floor b. On a wall for best line of sight to the PTAC Unit (see illustration 1) Illustration 1 2) Installation Materials Required EZ Touch IR Wireless Thermostat / base a. Four (4) AA alkaline batteries (included) b. Four (4) screws and anchors (included) c. #0 Phillips screw driver d.
) Detach the thermostat base as shown, by removing the two bottom screws BOTTOM SCREWS LOCATION Picture 1 Picture 2 Doc. 6140223 Rev.
) Secure the thermostat’s base to the wall using the four (4) screws and anchors supplied Picture 3 Picture 4 Doc. 6140223 Rev.
) Open the latch, insert the four (4) supplied batteries, secure the latch Picture 5 Picture 6 Doc. 6140223 Rev.
) Anchor the thermostat back to the base and secure it using the two (2) small bottom screws Picture 7 Picture 8 Doc. 6140223 Rev.
INFRARED RECEIVER INSTALLATION INTRODUCTION The EZ Touch IR receiver will be required when the PTAC unit has been installed inside an enclosure that does not allow direct line of sight between the digital controls and the wireless thermostat. INSTRUCTIONS 1) If required, drill a 5/8” diameter hole on the front cover, approximately 3 inches below the top, or the top panel of the enclosure, (See illustration 1) 5/8” dia.
INFRARED RECEIVER INSTALLATION 3) Connect the EZ Touch IR receiver (picture 10) to the 10 ft EZ Touch IR receiver extension harness (picture 9) that must be attached to the control board inside the PTAC unit (see location on picture 11) Picture 9 (EZ Touch IR receiver harness) Picture 10 (EZ Touch IR receiver harness) Doc. 6140223 Rev.
INFRARED RECEIVER INSTALLATION EZ Touch IR receiver harness connector Picture 11 (Control Board) 4) The blank off piece shown in picture 12 may be attached over the control pad location to instruct users to use the EZ touch IR on the wall. Picture 12 (PTAC Unit Digital Controls Blank off) Doc. 6140223 Rev.
