User Manual

CubeOne LED stays solid red
1. Ensure you have proper internet access provided by your ISP from
the connected router.
2. Ensure the port on the CubeOne and router are working. The LEDs
on the RJ45 jack should be solid green and flashing amber.
3. Ensure the CubeOne is receiving an IP address from the connected
router.
CubeOne is not found in app during setup.
1. Ensure the smartphone and CubeOne are connected to the same
local network.
2. Ensure the CubeOne is powered on.
3. Ensure the CubeOne LED is slowly flashing white (“breathing”).
After the registration process is complete, not all devices are
registered.
1. Remove battery from the un-registered devices. Wait at least 10
seconds and re-insert the batteries.
2. Observe the LED on each device during power-up. The red LED
should flash once. If not, replace the battery.
3. Launch the iSmartAlarm app and go to the More page.
4. Tap Device Settings.
5. Tap Add in the upper-right corner.
6. Select Devices.
7. After the devices have been found, tap Add to add them to the
system.
8. View the Device Settings page and ensure the device is shown.
26