User Manual

network cable.
ii. Wait until the iCamera begins rotating on its own. This takes 20
– 30 seconds.
iii. Tap Settings in the upper right corner of the iCamera page.
iv. Tap iCamera Wi-Fi Settings.
v. Follow the on-screen instructions to connect the iCamera
wirelessly.
vi. Disconnect the network cable when instructed.
vii. Tap Done after the network cable is disconnected.
2. Ensure the Wi-Fi password entered is correct during the iCamera
setup. To re-enter the iCamera Wi-Fi password, tap Settings and
tap iCamera Wi-Fi Settings.
3. Ensure your wireless router is set to support the Wi-Fi IEEE b/g
standard.
4. Ensure your wireless router does not have MAC Filtering enabled.
Unable to receive a live stream from the iCamera (First Generation)
when away from home or not on the same Wi-Fi network.
1. Ensure you have proper internet access provided by your ISP from
the connected router.
2. Ensure your smartphone has a wireless or data connection and can
access the internet.
3. Ensure your router’s UPnP is enabled.
4. Ensure port 17941 is forwarded to your iCamera’s IP address. Refer
to the port forwarding guides on https://iSmartAlarm.com/
30