User's Manual

13
GENERAL SAFETY AND PRECAUTIONS
1. Read all of the information in the Owner’s Manual and other included product information in the packaging before operating the product.
2. Prolonged exposure to alarm siren may cause permanent hearing loss
3. Battery may leak harmful liquids or ignitable materials or explode causing injury and product damage
4. To avoid damage as a result of battery leakage, remove batteries if the device is not going to be used for more than 3 months.
5. Do not mix old and new or other battery types
6. Replace fully discharged battery immediately
7. Do not run Adapter cable through wall
8. It may not be safe for people with pace makers to use the security system.
Contact sensors include parts with strong magnetic force.
9. Avoid using the iSmartAlarm
TM
near strong magnetic fields, such as microwave ovens, etc.
10. The Products may not perform accurately if stored or used outside the specified temperature and humidity ranges cited under Specifications.
11. Changes or modifications not expressly approved by iSmart Alarm Inc. invalidate the user’s warranty for this equipment.
12. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
13. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, could void the user’s authority to operate the equipment.
14. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:(1) this device
may not cause interference, and(2) this device must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
15. Under Industry Canada regulations ,this radio transmitter may only operate using an antenna of a type and maximum (or lesser ) gain
approved For the transmitter by Industry Canada . To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
16. NOTE: “This device” includes “CubeOne”, “Contact Sensor”, “Motion Sensor”, “Remote tag”