User's Manual

3. LED flashes red once when batteries are installed.

Note: Whenever removing and/or replacing batteries, you should wait at least ten

seconds before placing new batteries in the sensor and powering on the device. This

will allow the sensor's residual power charge to cycle through.

Remote tag:

How to change battery:

1. Unscrew and take off the back lid.

2. Replace the button battery with same type - CR2032.

3. LED flashes red once when the battery is installed.

Note: Whenever removing and/or replacing batteries, you should wait at least ten

seconds before placing new batteries in the sensor and powering on the device. This

will allow the sensor's residual power charge to cycle through.