User's Manual

Contact sensor:

How to change battery:

1. Take off the battery compartment.

2. Replace the button battery with same type - CR2032.

3. LED flashes red once when the battery is installed.

Note: Whenever removing and/or replacing batteries, you should wait at least ten

seconds before placing new batteries in the sensor and powering on the device. This

will allow the sensor's residual power charge to cycle through.

LED statuses of contact sensors, motion sensors and remote tags

1. Device has been added to the network successfully: LED flashes red twice

2. Devices are working normal: LED is off

3. Sensor has been triggered: LED flashed red once

4. Low battery: flash 3 times continuously within 3 seconds