F1 Jack Instructions rev4.pdf 1 5/17/2019 5:52:24 PM F1 Speaker Jack Instruc�ons C M Y CM MY CY CMY K IsoAcous�cs Inc. 39 Main St. N Unit 5 Markham, ON, L3P 1X3, Canada www.isoacous�cs.
F1 Jack Instructions rev4.pdf 2 5/17/2019 5:52:24 PM Appendix B The F1 Speaker Jack is a tool designed to assist with raising the side of a speaker for the Installa�on of the GAIA-TITAN isolators. Assistance is required to stabilize the speaker. Stepping Block – 2”x4” Wood block (Not included) Stepping Blocks are recommended when a speaker is narrow or low to the ground. The stepping blocks reduce the �lt angle of the speaker during the installa�on process.
F1 Jack Instructions rev4.pdf 3 5/17/2019 5:52:24 PM Appendix A Support Blocks (Recommended) ● Similar to using Jack stands underneath a raised car, Support Blocks (not included) are recommended to ensure the speaker is safely supported while in the raised posi�on. Support blocks should be between 4.3”to 4.9” (110mm to 125mm) in height. We recommend three stacked pieces of 2”x4” wood for the support blocks.
F1 Jack Instructions rev4.pdf 4 5/17/2019 5:52:24 PM Step #2 Raising the side of the speaker. Step #3 Install GAIA-TITAN ● With one or two people stabilizing the speaker and holding the F1 Jack handle flat against the ground, remove exis�ng feet/spikes and install the GAIA-TITAN in their place on one side at a �me. Step #4 Lower speaker down ● C M Y CM MY While one or two people stabilize the speaker, slowly lower the handle all of the way to the floor to carefully li� the side of the speaker.
