Owner's Manual

3
F1 Speaker Jack Instruc�ons
CAUTION: The F1 Speaker Jack is designed to assist with raising one side of
the speaker at a me. Two or more people are required for the installaon to
ensure that the speaker is secure at all mes.
Step #1 Posi�oning the F1 Jack underneath the speaker.
● Posion the F1 Jack underneath the speaker,
centered on top of the oor plate. The
speaker may need to be lted in order to
create enough space to slide the F1 Jack
underneath it.
● The F1 jack should be posioned in the middle of the side of the
speaker so that the speaker is balanced on the F1 Jack when it is in
the raised posion.
● The top pad of the F1 Jack must be posioned close to the edge of
the base of the speaker in a structurally solid locaon. Pooning
close to the edge is important to ensure that there is space between
the handle and the side of the speaker when jack is in the upright
posion
Side/Front View
Top View
6
Appendix A
Support Blocks (Recommended)
● Similar to using Jack stands underneath a raised car, Support Blocks
(not included) are recommended to ensure the speaker is safely
supported while in the raised posion. Support blocks should be
between 4.3”to 4.9” (110mm to 125mm) in height. We recommend
three stacked pieces of 2”x4” wood for the support blocks.
Top View
Side/Front View
Support Block
Stacked 2x4
4.5”
(115mm)
C
M
Y
CM
MY
CY
CMY
K
F1 Jack Instructions rev4.pdf 3 5/17/2019 5:52:24 PM