User's Manual

ISONAS Inc.
FCC ID: 0CZRC-03
IC: 8431A-RC03
This device complies with Part 15 of the FCC Rules and RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
 Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
 This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna. – Increase the separation between
the equipment and receiver. – Connect the equipment to an outlet on a circuit
different from that to which the receiver is connected. – Consult the dealer or an
experienced radio/TV technician for help.
 For RF Safety and per FCC and Industry Canada regulations, the product should
never be installed within 8-inches (20cm) of typical people locations.