User's Manual

How to Install the ISONAS IP-Enabled Reader-controller 10
1.5 POWERNET READER-CONTROLLER RESET BUTTON
The PowerNet reader-controller has a Reset Button located on the back.
It can be used for two different types of resets.
It is helpful if the PowerNet’s Ethernet cable is connected, and functioning (the
amber LED is lit). Monitoring the amber LAN status LED allows you to determine the
status of the reset operation.
 Reset CPU: Press, hold (approx. 2 seconds) and release the Reset button.
Once the Reset Button is released, the Amber LAN Status LED should turn off
(approx. 6 seconds), and then turn back on. If the Amber LED does not turn off,
then the reset did not occur.
 Reset Configuration: Press and hold the Reset button (approx. 10 seconds),
until the Amber LAN LED turns off. Selected reader-controller configuration is
reset to factory defaults. Setting that are changed include:
 IP Address (Default value: 192.168.1.27)
 IP Port (Default value: 10001)
Subnet Mask (Default value: 255.255.0.0)
Gateway (Default value: 0.0.0.0)
DHCP Setting (Default value: Off)
ACS Server (Default value: SrvrAcs)
ACS Server IP (Default value: 0.0.0.0)
Serial Port (Default values: 9600, 8, N 1)
Clear AES Encryption Configuration
Reset PowerNet’s Passwords