User's Manual

How to Install the ISONAS IP-Enabled Reader-controller 12
A standard CAT5 cable is then run between the PoE source (Injector or switch) and
the PowerNet Reader-Controller which will be located right next to the door. The
CAT5 cable can be up to 100 Meters (328 feet) long.
With one cable, you provided the required network connection and all the power that
will be needed at the door site.
PowerNet Supplying 12 VDC to Door Components
When using PoE, the PowerNet reader can supply 0.6 amps@12 Volts of power for
the external door components. This power can be routed to the lock control circuit
using the jumper pins. The supplied 12V power can also be accessed thru the
reader-controller’s Pigtail, when the reader’s jumper-pins are properly configured (on
Jumper block JP1, jumper pin 1 to pin 3). The power will be continuously available
on the Pigtail’s Red and Black conductors. You might use this 12VDC source to power
a Motion Detector located at the door location.