User's Manual

How to Install the ISONAS PureIP Reader-controller 9
1.4: INSTALLER TOOLKIT COMPONENTS
Before an installer goes to a customer site, they need to put together their supplies and tool-kit.
The ISONAS solution is simpler to install than other Access Control Systems, but materials are still
needed. And some of those materials may be different than what you are use to carrying. The list
below identifies some important items that you should make sure to bring with you, to the
customer’s site.
A prepared installer will have:
Installer completed the on-line reseller training program.
An installer’s Tool Kit should include the following:
1. The copy of the PureIP RC Installation and Wiring Guide
2. A Volt-Ohm Meter
3. Pin-in-Torx Screwdriver
o T-8 (Tamper Resistant)
4. 1 1/8 inch hole-saw (If mounting is done without a J-box)
5. A PoE Injector
6. A Cross-over Cat5/Cat6 cable
7. A straight-thru Cat5/Cat6 patch cable.
8. Basic Ethernet network cable tester (Tests for: Opens, Shorts, Split Pairs,
Mis-wires & Reversals)
9. A spare PureIP RC
10. An extra PureIP RC Pigtail
11. Silicon Caulking for sealing the PureIP to exterior walls
12. Dielectric Silicon Grease (Dow DC-4) for protecting cable connections.
13. The ISONAS PureIP As-Built forms, which is used to record the details of the
door's installation.
14. Credentials that match the customer system’s technology
o ISONAS Proximity
o HID Proximity
o DESFire EV2 Smart Cards