Product Manual
User Manual
55
Excess ice on the
evaporator.
Moisture inltraons in the
refrigerator.
Check the condions of the gasket on
all four sides of the door. The gasket
must close perfectly on the unit. If the
formaon of ice is thicker on one side,
most likely there is moisture inltraon in
the refrigerator is coming from that side.
Use a moderate heat source to model the
gasket into posion. If the gasket cannot
be modelled, replace the enre door.
The refrigerator cools too
much.
The thermostat sensor is
too covered or incorrectly
posioned
The end of the sensor must be in contact
with the evaporator. Set the sensor in
the correct posion. If the refrigerator
connues to cool too much, replace the
thermostat.
The compressor is noisier
than normal.
The compressor is not
properly secured on its
support or it is touching the
wall.
Check that compressor screws are properly
ghtened and that nothing is in contact
with it. The compressor vibrates and, if
something is in contact with it, vibraons
increase.
The fan/s is/are noisier than
normal.
The fan structure is bent or
the fan is broken.
Remove the clamps/screws used to secure
the fan. Replace if the fan connues to
make noise. Make sure that all of the fan
is intact. Replace if one or more ns is
missing.
The internal light does not
switch on.
Polarity reversed or broken
bulb.
Check bulb polarity. Replace light bulb if
polarity is correct.
Door/Drawer not closing
properly.
Incorrect posion of hinges or
deformed gasket.
Re-posion hinges so that the door closes
correctly. Use a moderate heat source
to remodel the gasket. Replace door if
problem persists. In the case of drawer
refrigerators, use the adjustable guides to
align the door.
For more complicated defects requiring specialised assistance, please contact Indel
Webasto Marine S.r.l. Italia or your nearest Isotherm retailer.