User manual

Replacement of the rechargeable battery
1. Unsrew and remove the housing cover.
2. Remove the old rechargeable battery from its fitting.
3. Insert a new rechargeable battery size Mignon (AA) and type Ni-MH with 1.2 V and
850 mA. When doing so, mind the correct polarity as shown on the bottom inside the
battery fitting.
4. Reattach the casing cover to the casing body and screw the casing in place.
General information
1. Electric appliances, packaging material etc. should be kept away from children.
2. Dispose packaging and worn out material correctly and in an environmentally
friendly way.
3. Do only pass on the device including the operation manual.
4. Subject to change of design and technical data without notice for the sake of
constant product improvement.
Safety instructions
Important: Damage caused by not adhering to the operating instructions is not covered
by guarantee. ISOTRONIC accepts no liability whatsoever for any resulting consequent
damages.
- Only operate the device at its intended voltage.
- In case of repairs, only use original spare parts, to avoid serious damage.
- Check feed cables and conducting cables connected to the device for breaks or
insulation defects. If you find a defect or there is visible damage do not use the
device.
- Repairs or other works, e.g. changing a fuse, etc. may only be carried out by an
appropriately trained, skilled person.
- It must be noted that operator or connecting errors lie outside the influence of
ISOTRONIC and we cannot accept any liability for resulting damages.
- Always check whether the device is suitable for the respective place where you
intend using it.
- This device is not suitable for use by persons (including children aged from 8 years)
with limited physical, sensory or mental capabilities or with a lack of experience or
nowledge, unless they are supervised and have been instructed in the use of the
device by a person responsible for their safety. Children should be supervised in order
to ensure that they do not play with the device.