Use and Care Manual

Recharging

We recommend charging your ISOtunes

™

fully before its ﬁrst use. Use the

included USB charger to connect to the micro-USB port on the controller

of the headphones. A red LED indicates your headset is charging, while a

blue LED indicates the charging has ﬁnished. When the battery is low, the

indicator light will ﬂash red, accompanied by periodic beeps. ISOtunes

™

supports iOS Bluetooth

battery level indicator.

Audio Control Functions

Volume Adjustments: Use the Volume Up (+) and Volume Down (-) buttons

to adjust the volume.

Play and Pause Music: Press the MFB once; or, separate/connect the

magnetic earphones; or, control on your Bluetooth

-enabled device.

Forward/Backward Song Selection: Press and hold the Volume Up (+)

button for 2 seconds to skip to the next song. Press and hold the Volume

Down (-) button for 2 seconds to return to the previous song.

Bluetooth Pairing

Press and hold the MFB until the indicator light ﬂashes red AND blue

interchangeably, or until you hear “Pairing” through the speakers. Your

ISOtunes

™

must be within 3 feet of the device you’re pairing with.

Search for and select “ISOtunes” in the Bluetooth

settings of your pairing

device. You will then hear “Paired. Your phone is connected.” through the

speakers. If prompted, use input code “0000” to pair.

After powering off and powering back on again, ISOtunes

™

will

automatically reconnect with its paired device, if in range.

To delete a pairing record, press and hold both the Volume Up (+) and

Volume Down (-) buttons until the red and blue LED light ﬂashes twice at

the same time. Then, when prompted by a “beep”, press and hold the MFB

for 3 seconds or until the devices are disconnected.