IMPORTANT SAFTEY INSTRUCTIONS! Please read this very carefully before operating this unit Read ALL instructions carefully before using this unit. Do not operate this unit near water, in the rain or where there is moisture. If this warning is ignored a serious electrical shock or death may occur. Do not attempt to service this unit. No user serviceable parts inside. Refer servicing to qualified, ISP approved service personnel.
Caution: Exposure to extremely high noise levels can cause permanent hearing loss. The HIGH DEFINITION LINE 2208 system is capable of producing in excess of 134db SPL at 1 meter. Continued exposure to noise levels in excess of 90db may cause permanent hearing loss. Below is a chart of the OSHA (Occupational Safety & Health Administration) regulations for Occupational Noise Exposure.
SUSPENDING LOUDSPEAKERS Important Notice!!! The information in this section has been gathered from engineering data and is for informational purposes only. None of the information in this section should be used without first obtaining competent advice with respect to applicability to a given circumstance. None of the information presented herein is intended as a representation of warranty on the part of ISP Technologies. Anyone making use of this information assumes all liability arising from such use.
REAR PANEL CONNECTION DIAGRAM
1. Two external amplifiers are required to power each HIGH DEFINITION LINE 4210 box. The ISP Technologies HIGH DEFINITION AMPLIFIERS are provided for ease of use and simple connection to a five-way digital crossover box. Make sure that the digital crossover box is configured with proper ISP Technologies approval, prior to use. 2. Make sure that all of the proper cables are available.
THERMAL CONDITIONS The ISP HIGH DEFINITION LINE 2208 Series is capable of producing in excess of 850 watts at full power. This generates heat that must be dissipated in order to maintain reliability and insure the amplifier components stay within their operating temperature specs. To accomplish this the amplifier is mounted on a heatsink that is internal to the cabinet. Airflow is forced through a port near the internal heatsink.
SPECIFICATIONS (per box) Configuration: 2-way LF Drivers: 2 x 8 inch, high sensitivity, neo magnet, water resistant cones. HF Drivers: 2 x 2.6 inch compression, 1.4 inch throat, neo magnet, polymer diaphragm, on multiple-aperture waveguide. Coverage: 100 H x 10 V Frequency Resp.: 68 Hz to 16 kHz Maximum peak SPL: 134 dB @ 1m Construction: Baltic Birch Plywood. Dimensions: 24” W x 9.1” H x 19” D Weight: 62 lbs. Amplifier: 850 W RMS, 3 channels high current DCAT, fan cooled.
WARRANTY AND SERVICE The Internal Circuitry is fully guaranteed to be free of defects under normal use and service for a period of two years from the date of purchase. The Speakers and Cabinet that are used in this product are fully guaranteed to be free of defects under normal use and service for a period of three years. Any damage resulting from the misuse or the failure to follow the precautions and instructions will void the warranty. In the event that the unit needs to be repaired.
