PRECAUTIONS! Please read this very carefully before operating this unit Read ALL instructions carefully before using this unit. Do not operate this unit near water, in the rain, or where there is moisture. If this warning is ignored a serious electrical shock or death may occur. Do not attempt to service this unit. No user serviceable parts inside. Refer servicing to qualified, ISP approved service personnel.
INTRODUCTION Thank you for your purchase of the ISP Technologies High Definition Distributed System HDDS SB112 Wall Mount Subwoofer. This product provides a new level of performance in distributed audio systems allowing greater system flexibility and easy installation of distributed sound. All connections are made via CAT6 RJ45 connections making installation of systems faster and easier using the HDDS SB112.
OPERATION The HDDS Master Control Module is the Master control center for distributed sound systems using the HDDS technology. The Master Control Module includes six zones that can be used independently or can be linked to work together allowing the system designer the flexibility to set up any system with the desired configuration. The block diagram below shows the basic configuration of the HDDS SB112 Wall Mount Subwoofer.
POWER DOWN THE MASTER CONTROL MODULE PRIOR TO CONNECTION TO THE HDDS SB112 MAY CAUSE POSSIBLE DAMMAGE TO THE HDDS SB112 OR THE CONTACTS PINS OF THE CAT6 CABLE DUE TO LARGE NON-SYMETRICAL INRUSH CURRENT. Rear Panel The rear panel POWER LED will light when power is applied from the Master Control Module. The rear panel of the HDDS SB112 includes two RJ45 input connectors, both for connection to a Master Control Module.
SUBWOOFER POWER: The HDDS system distributes low voltage Alternating Current over the CAT6 cable plus high level balanced audio and is capable of greater than 220 watts continuous power per HDDS SB112 subwoofer. Each of the three outputs A, B and C are capable of delivering up to 7 amps of output current. The current consumption at full power will require over 4 Amps of power per subwoofer.
Mounting the HDDS SB112 Refer installation to a qualified installer to ensure proper mounting to overhead structures. The HDDS SB112 includes a TV mounting bracket for easy install. Follow the mounting instructions included in the separate bracket mounting instructions included with the HDDS SB112.
HDDS SB112 SPECIFICATIONS Subwofofer Type: 1-way active Low Frequency: 12″ cone Crossover: 4th order LR high pass and low pass High Pass Filter: Switchable 40 Hz or 90 Hz – for use with a subwoofer Maximum SPL: 122 dB peak, 116 dB long-term Nominal Coverage Angle: 80 deg. H x 70 deg.
WARRANTY AND SERVICE The unit, parts and workmanship are fully guaranteed to be free of defects under normal use and service for a period of 3 years from the date of purchase. Any damage resulting from the misuse or the failure to follow the precautions and instructions will void the warranty. In the event that the unit needs to be repaired, please return the unit to ISP Technologies directly.