IMPORTANT SAFETY INSTRUCTIONS! Please read this very carefully before operating this unit Read ALL instructions carefully before using this unit. Do not operate this unit near water, in the rain or where there is moisture. If this warning is ignored a serious electrical shock or death may occur. Do not attempt to service this unit. No user serviceable parts inside. Refer servicing to qualified, ISP approved service personnel.
Caution: Exposure to extremely high noise levels can cause permanent hearing loss. The Trimax Speaker System is capable of producing in excess of 130db SPL at 1 meter. Continued exposure to noise levels in excess of 90db may cause permanent hearing loss. Below is a chart of the OSHA (Occupational Safety & Health Administration) regulations for Occupational Noise Exposure.
subwoofer cabinet is made of high quality 13 ply Baltic birch plywood with a durable spray on black finish for long life. PLACEMENT The Trimax Subwoofer is designed to sit on the floor or stage. Do not position or mount the cabinet where it can tip over and fall on someone. Do not attempt to mount the cabinet on speaker stands. Do not attempt to ‘fly’ (suspend by cables, chains, ropes, etc.) the cabinet. It was not designed for flying.
REAR PANEL DESCRIPTION 1. INPUT GAIN- This control determines the overall input level of the signal to the power amp section of the TRIMAX cabinet. Adjusting this level will not affect the level of the signal passing through to the output connectors. 2. BALANCED ¼” PHONE INPUT- This jack provides an input for balanced or unbalanced line level signal source. 3. BALANCED XLR INPUT- This female XLR connector provides an input for balanced line level source. 4.
FUSE REPLACEMENT 1. Use a small screwdriver as shown to slide the fuse cover out from the power inlet module. The fuse can be found inside the fuse cover module after it is pulled out. NOTE: A SMALL COMPARTMENT IS ALSO PROVIDED WITHIN THE FUSE COVER MODULE FOR STORING A SPARE FUSE. 2. After replacing the fuse with another of identical specifications, push the fuse cover module fully back into place, ensuring that the fuse has snapped onto the fuse holder inside the power inlet module.
CONNECTION DIAGRAM
SYSTEM DIAGRAM DESCRIPTION
SYSTEM DIAGRAM DESCRIPTION The ISP TRIMAX Series has balanced XLR and inputs and outputs configured to AES standards (Audio Engineering Society). These connections are connected in a loop through configuration from the inputs to the full range outputs and will accept a balanced line-level input. The standard phase configuration is that pin 2 is (+), pin 3 is (-), and pin 1 is shielded ground on the XLR.
SPECIFICATIONS System Frequency Range Frequency Response (-3dB) Horizontal Coverage Angle Vertical Coverage Angle Peak Output @ 1m Crossover Points Input Type Input Impedance Thermal Protection 40Hz - 20KHz TRIMAX 15 System = 35Hz –20KHz TRIMAX 18 System 45Hz - 17KHz TRIMAX 15 System = 40Hz –17KHz TRIMAX 18 System 90 degrees. 40 degrees. 130 dB 250 Hz, 1.9 KHz Balanced differential 10K ohms Output Drivers have internal protection, self resetting.
WARRANTY AND SERVICE The Internal Circuitry is fully guaranteed to be free of defects under normal use and service for a period of three years from the date of purchase. The Speakers and Cabinet that are used in this product are fully guaranteed to be free of defects under normal use and service for a period of three years. Any damage resulting from the misuse or the failure to follow the precautions and instructions will void the warranty. In the event that the unit needs to be repaired.