INTRODUCTION Congratulations on your purchase of the VECTOR CABINET. You are now the owner of the most innovative guitar speaker cabinet ever produced. The patent pending VECTOR ACTIVE GUITAR CABINET has bass on tap, designed as the perfect complement with maximum performance when used with the THETA HEAD. Years of experience in designing the highest performance Active Sound Reinforcement cabinets has allowed ISP Technologies engineers to develop the ultimate Active guitar cabinet.
VECTOR CONCEPT The VECTOR was designed for ease of use, simply connect the speaker output of the THETA HEAD, or any other guitar amplifier, to the input of the VECTOR, as you would for any other speaker cabinet, and get ready to unleash the most unbelievable low-end punch and bass performance you have ever heard.
VECTOR CABINET CONNECTIONS Connect the VECTOR cabinet as shown above. Connect the speaker output of the guitar amplifier to the input of the VECTOR cabinet using a speaker cable with a ΒΌ-inch jack connectors. Connect the IEC power cord to a proper AC supply wall outlet using the power cable supplied with the VECTOR cabinet. Turn on the guitar amplifier and then the VECTOR cabinet.
VECTOR AMPLIFIER 1. LIMIT LED The Limit LED will light when the D-CAT amplifier output signal exceeds the maximum output point. The internal limiter in the D-CAT amplifier will limit the output signal at the point of clipping and will not allow the amplifier to go into distortion. If the Limit light flashes on transients, it indicates that the limiter is being activated on the peaks of transients. This light will also light and remain on if the amplifier reaches the point of thermal protection.
4. INPUT JACK Connect the speaker output of your guitar amplifier to this input jack. The VECTOR will internally attenuate the speaker output and apply this signal to the input of the internal D-CAT amplifier to drive the subwoofer. 5. POWER SWITCH The power switch turns the VECTOR amplifier on and off. 6. POWER INLET Connect the supplied IEC power cable to this connector. FUSE REPLACEMENT 1. Use a small screwdriver as shown to slide the fuse cover out from the power inlet module.
WARRANTY AND SERVICE The Internal Circuitry is fully guaranteed to be free of defects under normal use and service for a period of three years from the date of purchase. The speakers and cabinet that are used in this product are fully guaranteed to be free of defects under normal use and service for a period of three years. Any damage resulting from the misuse or the failure to follow the precautions and instructions will void the warranty.