Instructions / Assembly

Installing the Drinking Water Faucet
1. If your kitchen sink does not have an existing ½” hole, you will have to drill one. (Refer to
How to drill a Hole in Your Sink or Counter-top
in our RO User Manual). Wipe clean and
dry the area.
2. Slide the front plate onto the faucet stem, followed by the rubber washer. Insert the faucet
stem into the hole on the countertop. Under the sink, slide on the back rubber washer, and
tighten the nut with the plastic wings (you may apply a few rounds of Teflon tape to the
threads to get a better grip).
3. Slide the quick connect fitting up the push-in adapter on the base so that it seats securely
into the faucet stem, then lock it in place by sliding the blue clip under the collet. Insert the
BLUE tubing about 1/2 inch into the push-in fitting, and again, secure it with the blue clip.

Summary of content (1 pages)