Install Instructions

iSpring Ice Maker Kit (ICEK)

How to connect the iSpring Water Filtration System to

your refrigerator using the Ice Maker Kit

Package Contains:

Quick Connect 1/4”

Tee Fitting x 1

Compression to

Quick Connect Fitting x 1

Quick Connect 1/4”

Inline Shut Off Valve x 1

20 Feet 1/4” Tubing

Spare Locking Clip x 1Compression Fitting

Set x 1

Connects any water ﬁltration

system (including reverse

osmosis systems) to the ice

maker or water dispenser of

your fridge.

Delivers crystal clear ice cubes

and great tasting RO water to

your fridge, superior to inline

fridge ﬁlters.

Kit includes everything you

need for the installation.

Tested by independent

third-party to meet NSF/ANSI

Standards.

Durable and easy to install

push-in quick connect ﬁttings

offer easy DIY installation with

no tools required.

Push-in quick connect ﬁttings

offer easy DIY installation with

no tools required.

www.123ﬁlter.com

Support@123ﬁlter.com

(678) 261-7611 | M-F 8:30AM-5:30PM

PAGE 1
iSpring Ice Maker Kit (ICEK) Package Contains: Quick Connect 1/4” Tee Fitting x 1 Compression to Quick Connect Fitting x 1 Quick Connect 1/4” Inline Shut Off Valve x 1 20 Feet 1/4” Tubing Compression Fitting Set x 1 Spare Locking Clip x 1 How to connect the iSpring Water Filtration System to your refrigerator using the Ice Maker Kit Connects any water filtration system (including reverse osmosis systems) to the ice maker or water dispenser of your fridge.
PAGE 2
1. Viewing from the open end, a quick-fitting starts with the Collet, Lock Clip (usually blue in color), and Fitting Body. 2. To connect, cut tubing evenly, remove the Lock Clip, push the tubing ½ inch into the quick-fitting, and reinstall the Lock Clip. Pull on the tubing gently to make sure it is locked in. 3. To disconnect, remove the Lock Clip and compress and hold down the Collet into the Fitting Body to eliminate the gap where the locking clip was occupying while simultaneously pulling the tubing out.