User Information The user must adhere to the installation specifications described in this Product Installation and Operation Manual (after this, referred to as the "instruction manual"). iSpring is not responsible for damage, loss, or injury resulting from neglect, improper maintenance, or unauthorized modification of products. • This product is designed for residential use only. Contact iSpring customer service to inquire about usage in non-residential settings.
Product Features 1) Product Scope • For residential use ONLY. • Applicable water quality: municipal.
Step 10. f. Shut off the RO Drinking Faucet. Open the Tank Shut-off Valve. Wait for the tank to fill up completely. This will take 1 to 2 hours depending on your water temperature (40°F 100°F, the warmer, the faster) and source water TDS (up to 750 ppm, the lower, the faster). Step 10. g. After the tank is full, open the RO Drinking Faucet to drain the tank completely. Do not use the first tank of water. Let it drain into the sink until the stream turns to a trickle.
Troubleshooting Trouble No output water from the RO faucet Tank not filling after several hours Leakage in connections Low water flow (trickle) from RO faucet Possible Issue a. Water supply is turned off. b. Incorrect installation. c. Crimped tubing impedes the water flow. a. Incoming water pressure is below 45 psi. b. Incorrect installation. c. Tank valve (ABV2K) is closed. a. Tubing is not inserted properly into the port. b. The O-ring inside the fitting is not creating a seal. c.
Glossary and Terms to Know Add-On Kit (#ACL1): Filter add-on kit for adding additional in-line filters to an existing system. It comes with quick-connect elbow fittings, filter clamps, and extra tubing Alkaline Remineralization Filter* (#FA15): 6th stage.
Pressurized Holding Tank (#T32M): 3.2 gallons capacity pressurized water holding tank. The air bladder forces the water to the drinking faucet when the faucet is opened. The tank comes prepressurized and should read 7-10 psi when empty psi: Pounds Per Square Inch, a unit used to measure water pressure Quick Connect Fitting: A secure, easy-to-connect, and disconnect type of fitting used on the system.
