Instructions / Assembly

www.123filter.com | [phone] | [e-mail] Page 20
Pressurized Holding Tank (#T32M): 3.2 gallons capacity pressurized water holding tank. The air
bladder forces the water to the drinking faucet when the faucet is opened. The tank comes pre-
pressurized and should read 7-10 psi when empty
psi: Pounds Per Square Inch, a unit used to measure water pressure
Quick Connect Fitting: A secure, easy-to-connect, and disconnect type of fitting used on the system.
The tubing is inserted past the tiny O-ring located inside each fitting, then locked into place by the
spider lock and blue clip
Reverse Osmosis (RO) Membrane (#MC7): 4
th
stage. High rejection, 0.0001 microns, thin-film
composite (TFC) reverse osmosis membrane, the heart of the reverse osmosis process
Stage 1, 2, and 3 housing O-Rings (#ORF): 3 5/8" O.D. O-ring used to create the seal between the
stage 1, 2, and 3 filter housings and their respective caps
Stage 1 See-Through PP Filter Housing (#HC12): Transparent stage 1 housing holds the sediment
filter. The see-through housing allows for the sediment filter to be visually inspected
Stage 2 GAC Filter Housing (#HW12): Solid white housing that holds the stage 2 GAC filter
Stage 3 CTO Filter Housing (#HW12): Solid white housing that holds the stage 3 CTO filter
T Fitting on Stage 5 Post Carbon Filter (#7544K): T fitting located on the right side of the stage 5
Post Carbon Filter
Tank Valve (#ABV2K): On/off valve that screws onto the top of the tank
TDS: Total Dissolved Solids, a measure of a water source's contamination level
TDS Meter (#TDS3): Handheld meter used to measure water quality
Tubing (#T14B / #T14W): 1/4" food grade tubing used on the system
UV Replacement Bulb* (#UVB11): Replacement bulb for the UV filter
UV Transformer/Ballast* (#UVT11A/UVT11B): Power supply for the UV filter. Indicator lights
on the ballast will only light up when water is flowing. UVF11A is for 110V power sources, UVF11B
is for 220V power sources