iSpring Reverse Osmosis Water Filter Systems OWNER’S MANUAL Ver 2005-6 Copyright ©2005-2015 ISPRING WATER SYSTEMS, LLC. All rights reserved.
Thank you for choosing the iSpring Reverse Osmosis Water Filtration System. It was built from quality components, and has earned WQA GOLD SEAL certification against NSF/ANSI STANDARD 58 for performance and material safety. Please check the attached iSpring RO Systems WQA Gold Seal Certification for details. OWNER’S MANUAL TABLE OF CONTENT Section 1: Knowledge Base .................................................................................................................. 2 What Is Reverse Osmosis? ..
Section 1: Knowledge Base What Is Reverse Osmosis? Reverse osmosis, also known as hyper filtration, is a membrane filtration process that separates undesirable materials from water by using pressure to force the water molecules through a semi-permeable membrane.
Fluoride 94-96% Strontium 90-95% Giardia 99% Sulfur/Sulfate 97-98% Hardness 93-97% Sulphite 96-98% Herbicides 97% TDS 95-99% Hydrocarbons 90+% THMs 90+% Insecticides 97% Trichlorethylene 90+% Iron 98-99% Virus 99+% Lead 96-98% Zinc 98-99% Magnesium 96-98% Note: You may or may not have these contaminants in your water. The percentage rejection rate is for reference only. Percentages may vary since water chemistry varies in each water supply.
What is DI filter? DI stands for deionization. De-mineralize filter takes the full size RO to a higher level of filtration. It is an excellent inline filter, especially those who live in areas with exceptionally high levels of TOTAL DISSOLVED SOLIDS (TDS) in their tap water. The post deionizer takes the small percentage of contaminants that the membrane could not remove and filters this to greater than 99.99% pure. It will give you close to 0 ppm TDS, Conductivity attainable less than 0.
Section 2: Troubleshooting Guide Leaking around filter housing (O-ring too small or not in place) First of all, please check if all filter cartridges are sitting upright inside the canister. Then, check if O-ring is properly in place. The o-rings may be a little too small, please stretch it out and put it back inside the groove. You may over-stretch a little so when it is back to the canister, it will shrink and fit just right. Then insert the cartridge to the top cap, screw the canister all the way up.
Tastes and Odors in Product Water Possible Cause Solution Carbon Post Filter is exhausted. Replace Filter. There is foreign matter in Holding Tank. Clean, flush and sanitize the Holding Tank. Replace filters. Product water and Drain water lines are reversed. Correct plumbing. Dissolved gases in feed water. Pre-treat feed water to remove gasses. Increase in Product Water TDS. See High TDS in Product Water Section Faucet Leaks or Drips Possible Cause Solution Water leaks from faucet spout.
• • • • • • • Reverse Osmosis Membrane is fouled. Air pressure in holding tank is incorrect. Air Bladder in Holding Tank is ruptured. Holding Tank valve is closed. No water to drain. Drain Flow Restrictor is clogged. Check Valve on RO Membrane Housing is stuck. The Automatic Shut-Off Valve is Malfunctioning. Will the water out of UV filter be hot? Traditional, the water coming out of the UV filter is a bit hot, up to 117F, for the first few seconds.
3020 Trotters Parkway Alpharetta, GA 30004 For questions or comments please visit us at: 123Filter.com For technical support, please contact us at: support@123filter.com 678-261-7611 www.123filter.com | (678) 261-7611 sales@ispringfilter.
