Install Instructions
Table Of Contents
- How to Use Quick-connect Fitting
- How to Use Compression Fitting with Brass Nut, Collar, and Tube Insert
- How to Drill a Hole in Sink or Counter-top
- Ice Maker Kit
- Step 1: Install Feed Water Adapter (AFW)
- Step 2: Install Drinking Water Faucet
- Step 3: Install Drain Saddle
- Step 4: Install the Vertical Filters: Stages 1, 2, and 3
- Step 5: Install Tank Shut-off Valve (Optional)
- Step 6: Install Reverse Osmosis Membrane
- Step 7: Tubing Hook Up (optional sub-steps are marked with * )
- Step 8: System Start Up (optional sub-steps are marked with * )
- Stages 1 – 3 Pre-filters: Replace every 6 – 12 months, depending on source water quality and clean water usage.
- How to Change In-housing Cartridges in 1st – 3rd Pre-filter Stages
- Stage 4 RO Membrane: Replace every 2 – 3 years or sooner if TDS level starts increasing.
- How to Change Reverse Osmosis Membrane
- Stage 5 T33 Fine Carbon: Replace every 12 months
- How to Change Inline Cartridges in 5th – 7th Stages
- O-rings: Replace every 3 years or sooner if leak happens at O-ring.
- UV Lamp (part# iSpring UVF11A) and Ice Maker Kit (part# iSpring ICEK)
- 空白页面
www.123filter.com | (678) 261-7611 | support@123filter.com Page 6
To Connect:
1. See Figures above. Check and cut the tubing end square and clean with a utility knife or
scissors.
2. Make a mark at the end of tubing. The lengh is about 1/2” - the depth of the fitting body.
3. Fully insert the tubing until the mark is almost invisible. This ensures that it is sealed by the
O-ring near the bottom.
To Disconnect:
1. See Figures above. Remove the blue Lock Clip.
2. With two fingers PUSHING IN and PRESSING DOWN the Lock Sleeve to eliminate the
Gap that the blue Lock Clip occupied, pull the tubing out. (Pressing down the Lock Sleeve
releases the spring-loaded steel teeth that grab the tubing inside the fitting body.)
How to Use Compression Fitting with Brass Nut, Collar, and Tube Insert
Compression fitting is used to connect the PVC tubing to the threaded metal inlet with a tapered
open end, such as the refrigerator water inlet, drinking faucet water inlet, etc.